Installation Of The Motor - V2 AYROS-24V Manual

Hide thumbs Also See for AYROS-24V:

Table of Contents

3 - INSTALLATION OF THE MOTOR

3.1 - POSITIONING OF THE MOTOR

To fix AYROS, follow the instructions below:

1. use the measurements indicated in the drawing for the

foundations

2. Arrange for one or two pipes for the passage of electric cables

3. Assemble the 4 clamps on the anchoring plate and fix them

with the 4 bolts issued with the motor

4. Pour the concrete and position the anchoring plate

WARNING: check that the plate be on a perfectly

levelled surface and parallel to the gate

343 mm

20 mm

60mm

5. Wait for the complete setting of the concrete

6. Unscrew the bolts fixing the base to the clamps and put the

motor on the plate

7. Adjust the 4 grains to make the motor be perfectly levelled

8. Control that the motor is perfectly parallel to the gate, then

insert the 4 washers R and lightly screw the 4 bolts D

WARNING: put the washer G into the hole for the

passing of the cables as shown in the picture. Pierce the

washer to let the cable to be connected to the control

unit pass, paying attention to the dimensions in order to

avoid the entrance of insects and other small animals.

- 34 -

Table of Contents