Servicing - GE Zoneline AZ9VH Owner's Manual And Installation Instructions

Installing the Zoneline
10. Install Filter
Note: Use only one filter in the installation
• For installs that will use a unit-mounted filter, slide
it down between the provided filter brackets on the
front of the unit, ensuring that any airflow direction
arrows on the filter are pointing toward the unit.
• For installs that will employ a filter within the return
mounted filter. Refer to instructions included in the
filter installation.
11. FINAL INSTALLATION
CHECKLIST
clearances around the unit have been adhered to
accessories have been installed properly and that
they have not been damaged during the installation
process.
caulked.
and outdoor coil are free from any obstructions.
the system.
they are connected and adequate for the removal
of condensate water and that they meet approval of
the end user.
outlet.
single circuit and is properly grounded.
with all applicable national and local codes and
12. Turn Power On
checked and are correct, turn the power ON to the
unit at the main service panel.
ON and check the unit to make
sure it is functioning as intended.
Quick Heat Recovery description
13. Adjust Auxiliary Control
Settings, if required
See the Auxiliary Control Setting section for
instructions on how to program the controls.
installation checklist before applying power to the unit.

SERVICING

WARNING
Risk of Electric Shock, can
cause injury or death.
power OFF at the service panel and lock the area to
prevent power from being switched on accidentally.
When the area cannot be locked, securely fasten a
prominent warning device, such as a tag, to the
service panel.
NOTE: We strongly recommend that any servicing be
performed by a qualified individual.
To remove the unit from the closet.
OFF unit at electrical disconnect.
connect kit from unit.
5. Disconnect the wall thermostat wiring from the unit.
Before servicing, switch
OFF.
49-5000640 Rev. 2