cecotec POWER ESPRESSO 20 SQUARE PRO Instruction Manual page 30

preheating.
-
When fitting the filter, please note that the filter has a small outlet which must fit into the
filter holder recess.
-
otherwise the filter holder will not be able to close properly.
-
- Place the cup on top of the waste-water tray (make sure that there is more than 150 ml
process).
-
complete.
-
At the end of the process the light will flash twice.
Milk preparation (Steam)
- Pour at least 50 ml of cold whole milk into the cup.
- Place the cup of milk in the steam pipe, making sure that the steam pipe is submerged in
the milk.
- Turn the selector towards the steam icon
flashes rapidly and the machine enters steam mode. At the beginning, it will be necessary
to wait for some time for the machine to warm up. This is normal. After heating, the
steam will automatically expel the frothy milk.
Note: before releasing steam, the device usually releases a little water, this is completely
normal because it is the residual water in the duct.
-
process.
Note: after 120 seconds of continuous steam blowing, if the rotary knob does not return to
again.
Reminder: as the machine has just finished steaming, the heating body inside the machine is
beginning of the process, some steam may be expelled.
Note: it is very important to clean the vaporiser after each use, by generating steam again in
a glass of water. Then, very carefully due to the high temperature, remove the protector from
the vaporiser and clean with a damp cloth the internal duct through which the steam comes
, at this point, the steam indicator light
POWER ESPRESSO 20 SQUARE PRO
ENGLISH
, to pause the
28