Jetpaks And Jets - BullFrog M Series Owner's Manual

JETPAKS & JETS
Interchanging JetPaks-
M Series, A Series,R
Series, and STIL
Step 1:
Put the spa in "Standby."
from activating (see Control Systems).
Step 2:
For M Series spas the Snap-Cap remains attached
to the spa. From the outside of the spa use both hands to pull
upward on the front of the Snap-Cap to release. Rotate and slide
back towards you to access the JetPak.
For A Series, R Series, and STIL spas remove the head rest and
Snap-Cap entirely by lifting upwards.
M Series
Step 3:
While applying pressure downward on the manifold
push the manifold toward the inside of the spa to release the
manifold from the wall clip assembly, then lift the jet plate
straight up to remove.
CAUTION!
WHILE PERFORMING STEPS 3 AND
4 YOU MUST USE THE BLACK MANIFOLD AREA
AS THE POINT OF CONTACT AS SHOWN IN THE
PICTURE. PRESSURE APPLIED TO THE FRONT FACE
(ACRYLIC PLATE) MAY CAUSE DAMAGE TO THE
JETPAK VOIDING THE WARRANTY
is will prevent the pump(s)
A Series, R Series, STIL
Step 4:
Exchange JetPak.
Step 5:
Lower the manifold of the new JetPak carefully as to
align the lower valve assembly and gasket into the bulkhead
tting. Apply pressure downward as you move the JetPak
manifold until the manifold is secured in the wall clip assembly.
Step 6:
Replace the Snap-Cap and head rest over the JetPak
and press down rmly to snap into place. For M Series snap caps
press down on the front part of the Snap-Cap to place and then
press rmly on the rear portion of the Snap-Cap to reengage the
snap feature and secure in place.
30