Sears Pro-Form CROSS WALK Owner's Manual page 6

OPERATION AND ADJUSTMENT
APPLYING SILICONELUBRICANT
has a grounding plug as shownin Drawing 1 below.
To reduce the friction of the walking belt and minimize
wear, a non-oil, non-petroleum-bosesilicone lubricant
must'beapplied to the walking platform before the
CROSS WALK is used. WITH THE POWER CORD
UNPLUGGED, lift each side of the walking belt and
spray lubricantgenerously onto the area shaded in the
drawing below. Reapply lubricant after every ten hours
of use, or whenever performance decreases.Lubricantis
available at hardware and automotive stares.
Uni*Sport
TM
spray is recommended.
Apply siliconeto the
entire shaded area.
PLUGGING IN THE POWER CORD
This product must be grounded. If it shouldmalfunction
or break down, grounding providesa path of least resis-
lance for electriccurrent to reduce the risk of electric
shock. Thisprndud is equipped with a cord having an
equipment-grounding conductor and a grounding plug.
Plug the power cord into an appropriate oudet that is
properly installed and grounded in accordance with all
local codes and ordinances.
DANGER:
Improper connection of the
equipment-grounding conductor can resultin a risk of
electricshock.Check with a qualified electricianor ser-
viceman if you are in doubt as to whether the product is
properly grounded. Do not modify the plug provided
with the product.-if it will not fit the outlet, hove a prop-
er outletinstalledby a qualified electrician.
This productis for use on a nominal 120-volt circuit, and
OutletBox
A temporary adapter like the adapter shownin Drawing
2 may be used to connectthis plug to a 2-pole recepta-
cle as shown in Drawing 2 if a properly grounded outlet
is not available.
2
,Grounding Pin
Grounding Plug
Lug
Metal Screw
The temporary adapter shouldbe used
only
until o prop-
erly grounded outlet (Drawing 1) can be installedby a
qualified electrician. The green-colored ear, lug, or the
like extending from the adapter mustbe connected to a
permanent ground suchas a properly grounded outlet
box cover. Whenever the adapter is used, it must be
held in place by a metal screw.
Some 2-pole receptacle oullet box covers are not
grounded. Contact a qualified electrician to defermine
if the outlet box cover is grounded before using an
adapter.
6