Table of Contents
Advertisement
GENERAL
ELECTRIC
MEDICAL
SYSTEMS
AMX-il X-RAY UNIT
7-1576
.
'
SM AO654E
FILLER CAP VENT PLUG
BAFFLE
.
LL CASE
(9.53mm)
IN THE FULLY CHARGED
CONDITION ELECTROLYTE
SHOULD BE APPROXIMATELY
3/8" (9.53mm) ABOVE BOTTOM
OF BAFFLE.
LEVEL OF ELECTROLYTE
IN TYPICAL CELL
16948-R11
LEVEL OF ELECTROLYTE
IN TYPICAL CELL
ILLUSTRATION 3-15
6-4
Battery installation in Unit
1.
Disconnect the battery leads and jumpers from each cell group. (Be sure to use the protective barriers
per Section 6-1, Step 12.)
2.
Fold back the Mylar covering the battery compartment.
3.
Slide one 30-cell group in the right side of the battery compartment. Before pushing it all the way in,
check that protective barriers are installed. Connect the lead out of the top main circuit breaker that
is labelled (+) to the right front corner terminal (shown as F in Illustration 3-14) of the battery pack.
4.
Slide another 30-cell group into the left side of the battery compartment. Before pushing it all the way
in, install the protective barriers, then connect the lead on the side of the main power circuit breaker
that is labelled (-) to the front left corner terminal (A in Illustration 3-14) of the battery pack.
5.
Slide the remaining 30-cell group into the center of the battery compartment.
Insert two 7-3/4" x
16-1/4" (2.12 m x 4.91 m) red insulator boards (furnished) between the right and center and two
others between the left and center ceil group.
These are to prevent the battery from sliding around.
6.
Two No. 6 AWG leads 6" (152.4 mm) long are furnished.
Use them to interconnect the left, right
and center battery packs.
Install the protective barriers, Illustration 3-13,
Connect B to C and D to
E as shown in Illustration 3-14.
After the connection, push the Temflex sleeving over the solderiess
terminal lug of each end of each jumper.
See Illustration 3-14.
7.
Place the Mylar cover over the battery compartment and reinstall the battery retainer plate and the
kick panel.
3-22
Advertisement
Table of Contents
