Siemens WT43N203FG Manual page 42

deTroubleshooting
Disturbance
Drying time is too
long.
Water is leaking out.
Laundry is too damp.
42
Cause and troubleshooting
Clean heat exchanger.
2.
→ "Cleaning the floor unit", page 36 .
Close ground unit.
3.
→ ""Close the ground unit", page 37 .
Device is not aligned correctly.
→
▶ "Aligning the device", page 16
Water drain hose is not connected correctly.
Make sure the water drain hose is connected
▶
correctly.
→ "Connecting the water drain hose", page 14
Unsuitable program set for the textile type.
Set a time program for drying.
▶
→ "Programs", page 25
Power supply has failed.
Check whether the room lights or other devices in
▶
the room are working.
Load quantity is too high.
Please note the maximum load capacity of the
▶
→ "Programs", page 25 .
Warm laundry feels damper than it actually is at the end of
the program.
Remove the laundry from the drum immediately after
1.
drying.
Spread the laundry items out to cool.
2.
Unsuitable drying target set.
→
"Change drying target", page 23 .
▶
Dry target not adjusted.
→ "Adjust drying target", page 23 .
▶
Load quantity too low.
Set a time program for drying.
▶
→ "Programs", page 25
Humidity sensor contaminated.
→
"Cleaning the moisture sensor", page 38 .
▶
Drying process stopped and condensation container
filled.
→ "Empty the condensation water container", page 32 .
1.
→ "Insert the condensation water container", page 33 .
2.