Siemens WT43N203FG Manual page 40

deTroubleshooting
Disturbance
Wrinkling.
and program
Broken.
40
Cause and troubleshooting
Load quantity is too high.
Please note the maximum load capacity of the
▶
→ "Programs", page 25 .
Laundry is left in the drum for too long after drying.
Remove the laundry from the drum immediately after
1.
drying.
Spread the laundry items out to cool.
2.
Unsuitable program set for the textile type.
Set the appropriate program for the type of textile.
▶
→ "Programs", page 25
Easy-care textiles dried for too long.
→
"Change drying target", page 23 .
▶
→ "Adjust drying target", page 23 .
▶
Anti-crease not activated.
Activate anti-crease.
▶
→
"Buttons", page 21
Condensation water container filled.
→ "Empty the condensation water container", page 32 .
1.
→ "Insert the condensation water container", page 33 .
2.
→ "Start the program", page 30 .
3.
Water drain hose is kinked or pinched.
Make sure the water drain hose is not kinked or
1.
pinched.
Lay the water drain hose without kinks.
2.
Water drain hose is not connected correctly.
Make sure the water drain hose is connected
▶
correctly.
→ "Connecting the water drain hose", page 14
Water drain hose is blocked.
Rinse the water drain hose with tap water.
▶
There is a foreign body in the floor unit
→ "Open the ground unit", page 35 .
1.
Remove any foreign bodies present.
2.
→ ""Close the ground unit", page 37 .
3.