Balboa CLIM8ZONE II User And Service Manual page 12

below.
Query code
* AP = Standalone; ** BP = Integrated with Balboa BP Spa Controller
7. Change Unit operation mode
Long press two buttons
A16: = 0 heat pump operates in AP mode; A16 = 1: heat pump operates in BP mode.
5.4. Query and setting of the system parameters
button
Query: Press
one parameter to another. Press
query.
Modify: To modify the parameter, a password will be needed. The password is 68. Follow the below procedure:

Long press

Press

Press

Press
buttons

Press
Meaning
A01 Inlet water temp.
A01 Outlet water temp.
A03 Ambient temp.
A04 Exust temp.
A05 Return gas temp.
A06 Outer coil temp.
A08 Electronic expansion valve
opening degree
A10 Compressor current
A11 Heat-sink temperature
A12 DC bus voltage value
A13 Actual compressor speed
A14 Total main board current
A15 DC fan speed
A16 Unit operation mode
and
for 3 seconds to enter the parameter query state. Press
button
to view the value of the parameter. Press
and button to enter the input password interface,
button to enter the first password digit "6" by pressing
button to advance to the second password digit and enter "8" by pressing
button to submit the password. After entering, select or change parameters by using
button to make entry changes or confirm and return to the viewing status.
Status Query Table
Display the range
-30~99℃
-30~99℃
-30~99℃
0~125℃
-30~99℃
-30~99℃
0~480
0~1590
0：AP* mode/1: BP** mode
for 15 seconds at the same time to switch between AP and BP modes;
or button to switch from
button to return and exit the
or buttons,
or buttons,
or
12