en
5 Cleaning and maintenance
5.1
Maintenance
W A R N I N G
➢ Servicing work may only be carried out by expert A.KRÜSS employees.
➢ Do not clean the device under flowing water or completely immerse it as
damage could thus be caused.
5.2
Cleaning
Note
Improper cleaning can damage the device
➢ Aggressive and abrasive cleaning agents can damage the refractometer.
➢ Avoid strong bases and acids. They damage the plastic housing.
➢
Do not clean the measurement prism with mechanical means (scraper,
tweezers, ...) to avoid damaging it.
Observe the following to ensure safe and reliable operation of the device:
▪
Correct cleaning of a refractometer is a basic requirement for precise
determination of the refractive index.
▪
The device should be cleaned before and after each use.
▪
If the cleaning procedure is carried out incorrectly, a very thin layer of the previous
sample may remain, which causes sample carry-over. An incorrect refractive index
will subsequently be measured for the next sample.
Details of
cleaning procedures
Instruction Manual DR201-95
available at the A.KRÜSS campus.
|
Version 3.1 © A.KRÜSS Optronic 2022
|
Page 21 of 30