TAKATA Mini Instructions Manual page 54

CAUTION!
Whenever you change the position of the carry handle,
always check that it is locked into place. To do this,
lightly push the handle back and forwards with your
hand, without pressing down on the levers.
Step 6 – Fasten the vehicle shoulder belt
[MINI_033] Bring the vehicleʼs shoulder belt around
to the back of the TAKATA MINI. Position it as
shown in the illustration.
CAUTION!
On the side with the seatbelt buckle, the shoulder
belt must run beneath the shoulder belt guide of the
TAKATA MINI. On the other side, where the seatbelt
rises to the upper attachment point in the vehicle, the
belt must run through the other shoulder belt guide.
Step 7 – Tighten the vehicle lap belt
[MINI_034] To tighten the vehicle lap belt, pull the
shoulder section of the seatbelt directly above the
buckle, until the lap belt section is suffi ciently tight.
Ensure that the lap belt is in no way twisted.
Step 8 – Tighten the vehicle shoulder belt
[MINI_035] Tighten the seatbelt, by pulling the
shoulder section towards the upper attachment point in
the vehicle.
Step 9 – Check the positioning
Ensure that the red line on the sticker affi xed to the side
of the TAKATA MINI remains in a vertical position. If
this is not the case, adjust the TAKATA MINI again.
WARNING!
Do not use any other force transmission points than
those specifi ed in this manual and indicated on the
TAKATA MINI (blue belt guides and carry handle in
the vehicle position).
de
en
fr
it
es
nl
49