SPL Track One Mk3 Manual page 7

GND Master
LIFT Slave
V
Hz
Fuse:
mA
COMPRESSOR LINK
GROUND
Compressor Link
The Compressor Link feature allows to operate two Track One
W A R N I N G
compressors with one control signal to ensure coherent stereo
TO REDUCE RISK OF FIRE
Use results.
OR ELECTRIC SHOCK DO
Stereo Jack
NOT EXPOSE THIS UNIT
(TRS)
TO RAIN OR MOISTURE.
The Master/Slave switch determines which device operates as
DISCONNECT MAINS
BEFORE REMOVING COVER.
master and which device is being controlled as slave.
C A U T I O N
RISK OF ELECTRIC SHOCK
D O N O T O P E N
CAUTION – PLEASE NOTE:
to Master! Both units would try to control each other – in worst
cases, damaging the units can not be excluded.
Therefore, always follow this procedure when activating
Compressor Link:
1.Determine the master device (switch not pressed).
2.Determine the slave device (switch engaged).
3.NOW connect both Compressor Link sockets with a stereo
jack wiring. Always determining the device status before
connecting the Compressor Link sockets excludes a mutual
control activity.
In Compressor Link mode the master device controls the
Compression, Make-Up and Limit controls of both compres-
sors. The respective controls on the slave unit are deactivated.
The Gain Reduction metering of the master unit now is the
master display for both units.
If the two units are to be used separately again, the wiring
must be disconnected and the slave unit must be set to master
again. (not pressed).
W I R I N G
XLR Wiring:
= GND, = (+), = (–)
TRS Jack Wiring:
Sle = GND, Tip = (+), Ring = (–)
Track One
TS Jack Wiring:
Sle = GND, Tip = (+)
AT T E N T I O N
RISQUE DE CHOC ÉLECTRIQUE spl.audio
N E PA S O U V R I R
Never switch two connected units
Track One Mk3 – Manual
Serial #
For unbalanced
operation use
Mono Jack (TS)
Sound Performance Lab
SPL electronics GmbH
Mk
Niederkrüchten
Germany
Bal. TRS
Made in Germany
EN
DE
Bal.
OUTPUT
7