Getting Started; Power Off - SPL Track One Mk3 Manual

Track One Mk3 – Manual

Getting started

Read the safety instructions starting on page 12.
Make sure that the mains voltage of the Track One Mk3 corresponds to the voltage of your
region and that the fuse has the correct value for the selected voltage (see specifications
on page 10).
The power switch on the back of the Track One Mk3 must be in the off position.
(Off = O / On = I).
Connect the supplied power cord to the power connector of the Track One Mk3 and to a
power outlet.
If the supplied power cord does not match your mains socket outlet, please contact your dealer.
The devices that are to be connected to the Track One Mk3 must be be switched off.
Connect your devices with appropriate audio cables (XLR) to the inputs and outputs of the
Track One Mk3.
Audio cables not included in the scope of delivery.
Power on
Switch on the power switch on the rear panel of the Track One Mk3 (On = I).
The PWR LED and all activated switches light up.
Activating phantom power
Please always follow these instructions to active and deactivate phantom power – also
when changing microphones. The input stage of the Track One Mk3 can be damaged if
you ignore these procedures.
1. Connect the microphone to the Track One Mk3.
2. Now activate phantom power to use the microphone.
3. After recording first deactivate phantom power.
4. Wait at least one minute after deactivation of phantom power before disconnecting the
microphone! This ensures residual current will be discharged.

Power off

Switch off the power switch on the rear panel of the Track One Mk3 (Off = O).
The PWR LED and all activated switches no longer light up.
2