Using For The First Time; Starting The Inverter For The First Time; Fronius System Monitoring (Pilot) Display; Installation With The App - Fronius Tauro 50-3 Operating Instructions Manual

Using for the first time

Starting the in- When starting the inverter for the first time, various setup settings must be con-
verter for the figured.
first time
If the setup process is cancelled before the process is complete, any data that
has been input up to this point is lost and the start screen with the installation
wizard is shown again. If the process is interrupted, such as in the event of a
power outage, the data is saved. Commissioning may be continued from the point
at which the process was interrupted once the power supply has been restored. If
the setup was interrupted, the inverter feeds energy into the grid at maximum
500 W and the operating status LED flashes yellow.
The country setup can only be set when starting the inverter for the first time. If
the country setup needs to be changed at a later date, please contact your in-
staller / Technical Support team.
Fronius system
monitoring (Pi-
lot) display
Installation with The "Fronius Solar.start" app is required for this installation method. Depending
the app on the end device with which the installation will be carried out, download the
app for the respective platform.
Fronius Solar.start
1
2
3
4
68
1
open access point
Download and install the Fronius Solar.start app.
Open the access point by touching the sensor
flashes blue.
Open the Solar.start app and follow the installation wizard. Scan the QR code
on the rating plate with a smartphone or tablet to connect to the inverter.
Add system components in Solar.web and start up the PV system.
To simplify the display, the vertical in-
stallation position of the Pilot pc board
(LED display) is shown horizontally be-
low.
Scan QR-Code and follow instructions
2
→ Communication LED