Table of Contents
Advertisement
salt component, you can switch off
the softening salt indication.
Remark
To prevent damage to the
device, only switch off the water
softening in the following cases:
¡The water hardness is max.
times 21 °dH and you use a
combined dishwasher detergent
with salt substitutes. Combined
detergents with salt substitutes can
only be used up to a hardness level
of 21 °dH without adding softening
salt, according to the
manufacturer's instructions.
¡The water hardness is 0 - 6
°dH. You do not need to use
softening salt.
Press.
1.
Approx. 3 seconds on
2.
to open the basic settings.
aThe display shows Hxx. aThe
display shows
to give.
Just as often
3.
the display shows H00.
To save the settings, press for
4.
approx. 3 seconds
aThe water softening system has been
is switched on and the refill salt
indicator is deactivated.
Busy-
display
press until
to press.
Softening system
10.5 Regenerating the
softening system
To maintain trouble-free operation of
the water softening system, the device
regularly performs a regeneration of
the water softening system.
The water softening system is
regenerated in all programs before the
end of the main washing cycle. This
increases the running time and
consumption values of, for example,
water and electricity.
Overview of the
consumption values
when regenerating it
softening system
Here you will find an overview of the
maximum additional running time and
consumption values when regenerating the
water softening system.
Regenerating the water
softening system after x
washing cycles
Additional running time in
minutes
Additional water consumption in
liters
Additional consumption of electricity in
kWh
The stated consumption values are
laboratory measured values
determined in accordance with the
currently applicable standard and
using the Eco 50° program and the
factory-set water hardness value 13 -
16 °dH.
6
6
5
0.05
27
Advertisement
Table of Contents
