Softening system
10.2 Set water softening
Set the device to the water hardness.
Determine the water hardness and the
1.
desired setting value.
→ "Overview of the water
hardness settings", page 25
Press.
2.
Approx. 3 seconds on
3.
to open the basic settings.
aThe display shows Hxx. aThe
display shows
to give.
Just as often
4.
the desired water hardness is set.
The factory setting is H04.
To save the settings, press for
5.
approx. 3 seconds
10.3 Softening salt
You can soften the water with water.
Fill with softening salt
If the refill softening salt indicator
lights up, top up the softening salt in
the softening salt container
immediately before starting the
program. The consumption of
softening salt depends on the degree
of water hardness. The higher the
water hardness level, the higher the
consumption of softening salt.
NB!
Dishwashing detergent can damage the
water softening system.
The water softener reservoir
▶
facility only
thing salt for dishes
26
Busy-
display
press until
to press.
with hair removal
fill washers.
The rinse aid container can be
corroded by dishwasher salt.
To ensure that spilled softening salt
▶
is flushed from the rinse aid
container, the softening salt must
be filled into the softening salt
reservoir immediately before the
start of the program.
Open the lid of the salt reservoir
1.
and remove it.
When using for the first time: fill the
2.
reservoir completely with water.
Remark:Only use special salt for
3.
dishwashers.
Do not use salt tablets. Do not
use table salt.
Pour the softening salt into the
softening salt reservoir.
Fill the softening salt reservoir
completely with softening salt. The
water in the reservoir is displaced
and flows away.
Attach and close the reservoir lid.
4.
10.4 Switch off water
softening
If the refill salt indication bothers you,
for example if you use a combined
detergent with