Step 4: Selecting Additional Settings And Functions - Hisense 9 Series User's Operation Manual

STEP 4: SELECTING ADDITIONAL SETTINGS AND
FUNCTIONS
User may set the laundry parameters and add additional functions as per need (before pressing
the Start/Pause button).
Before starting a program, touch the parameters or functions to be set, and turn ON/OFF the
corresponding settings. A parameter/function is ON if the corresponding icon lights up.
Touch the selected program time to change the Temp and Spin settings, and to set additional
functions such as Prewash, Extra Rinse, Anti crease, Quicker, Steam,UV, Quiet Mode,
Intensive and Stain Removal. More additional functions can be displayed by sliding left and
right. Additional functions that can be selected vary with the program.
Temp.
For adjusting the heating temperature during washing.
1. Tap the Temp option to enter the Temp selection interface;
2. Swipe on the screen to select the desired washing temperature among Cold-20°C-30°C-40°C-
60°C-90°C.
Each program has a maximum set temperature, which should not be exceeded when selecting
the temperature.
3. After selection, tap the "OK" button for confirmation, or tap the "CANCEL" button to abandon the
selection.
Spin
For adjusting the maximum spin speed.
1. Tap the Spin option to enter the Spin selection interface;
2. Swipe on the screen to select the desired spin speed among No Spin-400-600-800-1000-1200-
1400. When "No Spin" is selected, the washing machine will only drain the water without spinning.
3. After selection, tap the "OK" button for confirmation, or tap the "CANCEL" button to abandon the
selection.
Prewash
Add a prewash process which will last for a while before the Main Wash phase. Generally, it is
used for dirty clothes.
When Auto Dosing is turned on and Prewash is selected, the detergent dosage in the Prewash
phase is half of that in the Main Wash phase. The detergent dosage in the Prewash phase will not
affect that in the Main Wash phase.
Extra Rinse
It is used to add the rinse times.
This function can be selected when the machine is in standby and cannot be changed after start.
34