Interruptions And Changing Program - Hisense 9 Series User's Operation Manual

INTERRUPTIONS AND CHANGING
PROGRAM
ADDING/REMOVING LAUNDRY DURING OPERATION
The appliance door can be opened if the water level and water temperature are below a
predefined threshold.
The door will be unlocked automatically if all the following conditions are met:
• water temperature in the drum must be suitable.
• water level in the drum must be below a certain value.
In order to add or remove laundry from the appliance during a washing program, proceed as
follows:
1. Press the Add Clothes button to suspend the laundry program.
2. If all conditions for unlocking the machine door are satisfied, the door will be unlocked. Open
the machine door to add or reduce clothes in the drum.
3. Close the appliance door!
4. Press the START/PAUSE button.
If you add a considerable amount of laundry during the wash, the laundry could be washed less
effectively, since the washing machine initially sensed a lower weight of the load of laundry and
added a smaller amount of water. Insufficient amount of water relative to the amount of laundry
could also cause damage to the laundry (rubbing of dry laundry), and washing time can be longer.
Washing time will resume from the point at which the washing programme was interrupted.
Manual Interruption of Program
To stop and cancel the washing program,
• touch the Back button (<) at the upper left corner of the screen; or
• long press the "Power" button for 3s to power off the machine;
Change of Program
To change the program during the laundry, first manually interrupt the current program by the
above method, and reselect a program.
ERRORS
If the machine malfunctions, the program will be interrupted.
In such case, the machine will produce a prompt tone to alert you, and the screen will display a
fault message.
In the case of partial abnormality alarms, click the Start/Pause button to cancel the alarms
and return to the running state. It cannot be switched to the running state in the case of partial
abnormality alarms.
POWER FAILURE
In case of a power failure (power outage), the washing program is interrupted. When the power
supply is restored, the program is resumed from the point where it was interrupted.
If there is still water in the washing machine after a power outage, make sure not to open
the door before you manually drain the water from the washing machine via the pump filter.
43