Electrical Connection; Preparing The Ac Connection - Kaco Powador 12.0 TL3 - INT Operating Manual

Electrical connection

Authorised electrician
7 Electrical connection
EN EN
Lethal voltages are still present in the terminals and cables of the inverter even after the
inverter has been switched off and disconnected.
Severe injuries or death will occur when touching the cables and terminals in the inverter.
›
›
›
›
›
›
7.1

Preparing the AC connection

7.1.1 Open connection area
3
Figure 12: Connection area: Open connection cover
Key
1 Connection cover
2 Screws for mounting (long)
Open connection area
You have mounted the inverter on the wall.
1. Unscrew the four Torx screws on the front side of the connection cover (blue).
2. Pull down the connection cover.
» Make the electrical connections.
NOTE
Remove only the connection cover (blue). Opening the housing cover (grey) will invalidate the
warranty.
Page 16
DANGER
Only appropriately qualified and authorised electricians may open and install the inverter.
Observe all safety regulations and the current technical connection specifications from the relevant
power supply company.
The inverter must be mounted in a fixed position before being connected electrically.
Disconnect the AC and DC side.
Secure the inverter against reconnection.
Ensure that the AC and DC sides are completely voltage free.
1
2
3 Screws for mounting (short)
Operating Instructions Powador 12.0 TL3-20.0 TL3