Table of Contents
Advertisement
13.3 Adapter-connector for ERN 1387
Test adapter set for rotary encoders with analog commutating signals
(e.g. ERN 1387 with incremental track Zn and commutating track Z1)
Testing the ERN 1387 without subsequent electronics!
Adapter set Id.No. 341 338-01
Note:
If the ERN is tested without subsequent electronics, the terminating resistor on the PWM 8
must be switched off.
See PWM 8 Operating Instructions Id.No. 312 737 91 page 13 softkey options.
The terminating resistors are integrated in the D-sub connector Id.No. 341 339 01!
:
CAUTION
If the ERN is to be tested without subsequent electronics (NC), the adapter cable
Id.No. 341 340 01 (see graphic) must always be used!
The 17-pin right-angle flange socket on the servo drive may have different!
59
-
-
Advertisement
Table of Contents
