Table of Contents
Advertisement
5.2.2 The Parameters
By means of parameter programming several PWM 8 settings can be changed.
After pressing the soft key
programming is displayed. When commissioning PWM 8 the parameter default setting is as follows:
If parameters are changed, PWM 8 internally stores the changes. When the PWM 8 is switched on again,
the stored parameter values are loaded.
If parameter values have been stored that are different from the standard setting and the EXPERT MODE is
not active, the standard setting can be loaded from the Options soft-key row.
However, the parameter P1 Dialogue is not changed.
5.2.3 Parameter Overview
Parameter P1: Dialogue Language
[GERMAN, ENGLISH]
[GERMAN, FRENCH,]
The dialogue of PWM 8 can be switched. Possible language combinations are German/English and
German/French.
in the soft-key row of the EXPERT MODE, the menu for parameter
Software Id.No.: 246 199 xx
Software Id.No.: 246 200 xx
- 25 -
Current parameter setting
Terminate parameter programming
All parameters are reset to their default values (fig.:
parameter default setting)
The highlighted parameter can be changed by
pressing the soft key CHANGE
By pressing these soft keys the highlighted field can
be moved to the parameter to be edited.
With this soft key the parameter default setting can
be loaded in the Options soft-key row.
Advertisement
Table of Contents
