Display Of The Pwm 8 Mode: Measure U/I In The Mode Window - HEIDENHAIN PWM 8 Operating Instructions Manual

4.4.1 Display of the PWM 8 MODE: MEASURE U/I in the Mode Window

Depending on the power supply of the encoder and of PWM 8, the MODE MEASURE U/I may be displayed
differently in the MODE window:
MODE: MEASURE U/I of encoders with sensor lines
(TTL, HTL, 1Vpp interface boards):
• and internally powered encoder (= via power supply unit) or
• externally powered encoder and parameter: P2 U-MSYS EXTERN = FLOATING
Special feature of HTL interface board:
A floating power supply of the encoder is not possible. The parameter P2 has no function.
The MODE MEASURE U/I is displayed as follows with HTL interface board:
• externally powered encoder and parameter: P2 U-MSYS EXTERN = FROM CUSTOMER
Floating power supply of the encoder with relation to the
subsequent electronics.
Current consumption of the encoder
Power supply of the encoder
(here: floating)
Sensor lines of the encoder
Special feature of HTL interface board:
The encoder is powered by the power
supply unit (= internally) without potential segregation.
The encoder is powered directly by the subsequent
electronics without potential segregation.
Current consumption of the encoder
Power supply of the encoder
(here: customer voltage)
Sensor voltages of the encoder
- 18 -