Color Burst Phase, Width Adjustment; Carrier Balance Adjustment - Panasonic DVCPRO AJ-CA901P Service Manual

Electrical Adjustment for AJ-BS900HP & CA900HP
4-2. Color Burst Phase, Width
Adjustment
BOARD BS AUDIO
TP ENC1 OUT
ADJ. VR13 [BF PHASE], VR14 [BF WIDTH]
INPUT
AJ-BS900H Internal Color bar signal
M. EQ Oscilloscope
SPEC. A = 5.3µS +/- 0.1µS
B = 9 Cycle
1. Set output signal mode on the AJ-BS900H to
Internal Color bar mode. (Press "BARS" button on
the AJ-BS900H.)
2. Connect Oscilloscope to ENC1 OUT connector
and then adjust VR13 so that the Burst signal
phase A is within the specification.
3. Connect Oscilloscope to ENC1 OUT connector
and then adjust VR14 so that the Burst signal
width B is within the specification.
B
A

4-3. Carrier Balance Adjustment

BOARD BS DIGITAL
TP ENC1 OUT
ADJ. VR19 [R-Y BLK BAL], VR22 [B-Y BLK BAL]
INPUT AJ-BS900H Internal Color bar signal
WFM (With 75 Ω termination, 5x mode)
M. EQ
SPEC.
A=Carrier component level: minimum.
1. Set WFM as shown below.
GAIN : 5x
FILTER : CHROMA mode
2. Connect WFM to ENC1 OUT connector and then
adjust VR19 and VR22 so that the signal carrier
level (A) is within the specification.
ELE-4
A
A