Removal Of Battery Holder; Cable Connections Part 1 - Panasonic DVCPRO AJ-CA901P Service Manual

1-3-2. Removal of Battery Holder

1. Remove 4 Screws (A).
2. Disconnect Power Connectors P9807 and P1006
and then remove Battery holder.
3. Unscrew 2 screws (B) and then remove a
connector cover.
Screws (A)
Fig. 3-1
Power connectors
Fig. 3-2
Screws (B)
Fig. 3-3

1-3-3. Cable Connections part 1

1. Loosen 4 screws and then remove Side panel
(Cassette slot side) on the Unit.
2. Wire harness from AJ-CA900H base plate should
be passed through rear panel as shown below.
3. Connect Power connectors on Battery holder to
connector P9807 and P1006.
4. Fix "GND Cable" with Gold Screw (Included with
AJ-CA900H) to Camcorder as shown figure 3-5.
(GND Cable have to be fixed on the direction of the
lower right at 45 degrees.)
5. Connect Flat cable to connector P9806 on INT
CONNECT P.C.Board.
Power connectors
Flat Cable
GND Cable
INS-3
Fig. 2-4
Fig. 3-5