Advertisement
Quick User Guide
Charging Recommendations
•
When the battery is low and all indicators are off - the cleaner is on standby mode.
Connect to the charger to wake it up.
•
Always charge the pool cleaner in a protected and shaded area at a temperature range of
6°C - 35°C / 43°F - 95°F, until you see 3 green bars in the battery indicator panel (up to 6 hours).
•
The charger is rainproof, the robot can be charged when wet. However, do not put the
charger in the water. It is not designed to be underwater.
Off-Season Storage
Before off-season storage - Charge the battery to about 50% (2 green bars in the
battery indicator panel).
Recommended storage temperature range: -10°C - 40°C / 14°F - 104°F.
Exceeding the maximum will likely damage the battery.
After off-season storage, charge the robot to its fullest.
Info and recommendations
Note
•
Keep your fingers away from the impeller motor area to avoid injury.
•
Any maintenance should be done only when the robot is off.
•
Ensure that the electrical outlet is protected by a ground fault interrupter (GFI) or earth
leakage interrupter.
•
Do not put the charger in the pool.
•
Do not enter the pool while the pool cleaner is working.
•
In case of any physical damage to the pool cleaner or the charger, contact Customer Care
for instructions.
•
When removing the robot from the pool, set it on the edge to empty the water before lifting.
•
Water temperature range: 6°C - 35°C / 43°F - 95°F
•
Water depth range: 0.4m - 3m / 1.33ft - 9.8ft
•
Motor protection: IP 68
•
Charger protection: IP 54
•
Chlorine - 4 ppm, Max.
•
pH - 7.0-7.8
•
NaCl - 5000 ppm, Max.
•
Battery Lithium-ion | 5,000mAh
Scan for User Manual
For more information www.maytronics.com.au
|
EN - LIBERTY Quick User Guide | 4
Advertisement
