Advertisement
1.1
Wall Mounting Preparation
Before mounting the switch, you need to prepare the tools below:
Ǵ
A screw driver.
Ǵ
Two screws which complies to the corresponding standard. For details, see
Mounting
1.2
Wall Mounting Procedure
On the bottom of the panel, there are two mounting holes. You need to drive two screws
into the wall, then mount the switch on the wall. Note that the switch should be mounted
on the wall upright rather than sideways. For TL-SF1008P/TL-SF1008LP/TL-SF1009P/
TL-SG1008P, the switch should be mounted with the ports facing downward and the
LEDs facing upward.
1) Determine the location on the wall where you want to mount the switch.
2) Mark the wall where the two mounting holes are. The distance between the two marks
must be the same as that between the two mounting holes of the switch. For the wall-
mounting-holes distance, see
3) Drive the screws into the wall at the marks using the screw driver. For the Screw-
Head-to-Wall Minimum Distance, see
4) Mount the switch on the wall.
1.3
Wall Mounting Specification
Model
DS105G
DS105GE
DS105G-M2
DS105GP
DS105X
DS106GPP
DS106P
DS108G
DS108GE
DS108G-M2
DS108GP
DS110GMP
Specification.
Screw Standard of
ANSI B1.1
4#, (5#), 6#, 8#
4#, (5#), 6#
4#, (5#), 6#
4#, (5#), 6#, 8#
4#, (5#), 6#
4#, (5#), 6#, 8#
4#, (5#), 6#, 8#
4#, (5#), 6#, 8#
4#, (5#), 6#
4#, (5#), 6#
4#, (5#), 6#, 8#
4#, (5#), 6#
Wall Mounting
Specification.
Wall Mounting
Minimum Length
of Screw
7.5mm
7.5mm
7.5mm
8.5mm
7.5mm
8.5mm
8.5mm
7.5mm
7.5mm
7.5mm
8.5mm
8.5mm
Specification.
Screw-Head-to-Wall
Wall-Mounting-Holes
Minimum Distance
1.5mm
1.5mm
1.5mm
1.5mm
1.5mm
1.5mm
1.5mm
1.5mm
1.5mm
1.5mm
1.5mm
1.5mm
Wall
Distance
39mm
52mm
52mm
39mm
150mm
94mm
94mm
94mm
110mm
110mm
94mm
150mm
Advertisement
