atd models Stone Workshop ATD010 Instruction Manual page 5

11c. Glue the infills into position, as per the
illustration below.
12. Glue the Chimney Breast into position, as
per the illustration below.
14. Glue the Trussing into position, as per the
illustration below.
11d. Fold the lower tabs, wrapping them around
the infills and glueing together.
13. Detach the trussing (x2). Carefully glue them
together, back to back. Repeat this step for
the remaining trussing.
15. Fold the chimney stack along the crease lines
and glue into position.