atd models Stone Workshop ATD010 Instruction Manual page 4

8. Now turn the building on its side. Detach the
Ground Floor and glue it into the building.
You will notice that there are notches
i
cut out in the wall that will align with the tabs
on the floor like a jigsaw. There is no tab
where the floor sits behind the door.
You may find it easier to apply glue inside
the notches before positioning the tabs.
9a. Detach the Ground Floor Chimney Breast
and then fold it along the crease lines.
10. Detach the 1st Floor and glue it into position.
You will notice that there are notches
i
cut out in the wall that will align with the tabs
on the floor like a jigsaw. Before glueing the
component into position, ensure that the
notches line up with their corresponding tabs.
You may find it easier to apply glue inside
the notches before positioning the tabs.
11a. Detach the chimney infills and fold, as per the
illustration below.
9b. Glue the Chimney Breast into position, as
per the illustration below.
11b. Detach the 1st Floor Chimney and fold the
upper tabs, as per the illustration below.