Page 1
Slate Tile Roof Hook-Portrait INTRODUCTION Thank you for selecting and buying V-TAC Product. V-TAC will serve you the best. Please read these instructions carefully & keep this user manualhandy for future reference. If you have any another query, please contact our dealer or local vendor from whom you have purchased the product.
Page 2
NATURAL & ARTIFICIAL SLATE A-SLATE INSTALLATION GUIDE Allow a maximum of 1.2m between tile brackets depending on site condition RAFTER PSN CENTRAL Pre drill the base plate with a 7mm drill. Pre drill the slate covering with a 10mm drill. Apply CTI Sealant to the 7mm holes, bottom of the base.
Page 3
DRAWING AND BOM OF A-SLATE AS FOLLOW NAME SPEC MATERIAL Base 164x265x60mm Aluminium 6005-T5 1 pcs L-Bracket 60x70x80mm Aluminium 6005-T5 1 pcs Rubber Pad 164x265mm EPDM 1 pcs Screw St 6.3x100 Steel 10B21 2 pcs THE INFORMATION OF SPACER AS FOLLOW 10mm x 8.2mm x 20mm Spacers - Black Nylon Technical Specification...
Page 4
PROCEED WITH INSTALL OF A-SLATE AS FOLLOWS A er locating the battens, B1 Drill out a 7mm test ho Using Place aluminum bases in the fixing & B2 and ra er R positions. a screw driver, gently. position as shown. Hold and drill Mark the test hole position X confirm the ra ers central through the 2 marked fixing points...