Eps; Care And Maintenance; Specifications - EcoFlow RIVER 2 Manual

EPS

EPS
The product supports emergency power supply (EPS). Please connect the grid power to the AC input port of the
product through an AC cable, then power your device through the AC output port of the product (as figure below).
AC power will come from the grid instead of the power station in this situation (bypass mode). In case of a sudden
blackout, the product can automatically switch to ba-ery-powered supply mode within 30ms.
1. As a basic UPS feature, it does not support 0ms switching. Please do not connect the product to any device that
requires 0ms UPS (such as data servers and workstations). Please test and confirm the compatibility before using
the product.
2. It's recommended that you power only one device (with maximum power <1600W for high voltage areas and 1000W
for low voltage areas) at a time and avoid using multiple appliances at the same time to avoid triggering overload
protection. EcoFlow takes no responsibility for any device failure or data loss caused by failure to follow instructions.

Care and Maintenance

Care and Maintenance
1. For safety, please do not store the product in temperature higher than 45°C (113°F) or lower than -10°C (14°F) for
a long time.
2. For long-term storage, please recharge the product every three months (firstly discharge it to 0%, then recharge it
to 60%). The product will not be covered by the warranty if it is not charged or discharged for more than 6 months.
3. If the product has been idle for too long and the ba-ery is severely low, it will enter a deep sleep protection mode. In
such case, please charge the product before using it again.
Specifications Specifications
GENERAL
Model EFR620