ProRacing TS2 PRO User Manual page 5

3 Installation
Phase 1 of 6 - preparing the installation
Let the engine cool down before installing the Proracing ECU, you could burn yourself.
Open the bonnet and keep the doors locked.
1
2 Wait about 10 minutes before acting, in this way all the electrical equipment will be
deactivated.
Normally, no special tools are required for installation, a wire cutter is su cient to remove
the remains of the clamps. In some cases a torx key to open the control unit and change
to Bosch or Siemens / delphi.
• With, Keyless Go or electronic key, be careful to keep the car key at a distance
about 10 meters from the car to be out of radio coverage.
In the event of an anti-theft device, it must be deactivated before starting the installation.
•
In some rare cases it is possible that the car with the hood open keeps the sensors
•
active, therefore it is advisable to disconnect the battery positive to avoid generating
an error.
If you have any questions or problems during installation, you can nd answers on
•
Error removal.
Our customer support is also available - You can open a Ticket
•
on our website.
5