ProRacing TS2 PRO User Manual page 11

5 First start-up
Phase 5 of 6 - First start test.
1
Connect the control unit to the wiring.
If the control unit turns on during installation with the ignition o , it means that
•
during the connection there was still residual current in the car's wiring.
• This can cause in some cases an error in the dashboard, the control unit
Engine ECU may have detected a wiring harness disconnection.
2
Carry out a rst function test
Rest Proracing with the harness securely possibly already clamped in such a way
•
that no moving part of the engine can create problems.
•
Now start the engine and check that the ECU turns on.
•
Please note that after about 1 minute it goes into standbay mode and turns o but this is normal.
Turn o the engine and complete the installation of the wiring with the supplied cable ties.
•
If the car does not start regularly or you have reports on the dashboard
proceed with the paragraph '' Removing errors ''
Of course, our customer service is also at your disposal.
Phase 6 of 6 - End of installation.
Route the corrugated pipe of the wiring along a suitable point and secure it with cable ties.
When choosing the xing point of Proracing also make sure that it is
•
protected from water, strong heat and vibration.
• Do not put Proracing in a bag as this can form condensation
of water.
Do not x the wiring on parts that can get hot at very high temperatures,
•
(e.g. exhaust manifold, dpf or turbochargers.
11