Troubleshooting - Pioneer MJ-D707 Operating Instructions Manual

Troubleshooting
Symptom Possible Causes Treatment
Sound is not output. |e The power cord is unplugged. Connect the power cord correctly.
@ Ajfconnection cords are not cannected completely. | e Connect the cords correctly by referring |
to the connection instructions.
i
i
sat a oa es Ls a |
Recording is monaural. @ The MD recorder is in the long-hour monaural | @ Use the stereo recording mode.
recording mode. |
"No Disc" is displayed when | @ The disc is scratched. @ Use another MD.
an MD is loaded.
Sound is intermittent. |e Dewis condensed inside the MD recorder. @ Leave the MD recorder for about an hour |
before retrying playback,
The remaining recording time | @ Tracks shorter than 12 seconds are sometimes not | @ This is nota malfunction.
cannot be increased after counted by the recording time information.
erasing some short tracks.
: —— —
The total of the recorded time | @ As the minimum unit of recording is 2 seconds, a | e Thisis nota malfunction.
and remaining recording time of space of 2 seconds is always used even when the
an MD does not match the length of track is shorter. As a result, the actually
maximum recording time of the available recording time may be shorter than the
MD, value calculated based on the displayed time
information.
@ The disc contains a non-recordable section due to | e Use another MD.
scratch, etc. |
Tracks cannot be combined. @ This trouble occurs when the MD experienced | Thisis nota malfunction.
| repeated recording and editing operations. }
e@ An attempt is made to combine a track recorded | @ A track recorded using the digital input
using a digital input with a track recorded using the cannot be combined with a track
analog input. recorded using the analog input.
e The picture of a nearby TV may be interfered with noise from the MD recorder, particularly when the TV uses an indoor antenna. In this
case, use an outdoor TV antenna or install the TV set more apart from the MD recorder.
@ This unit may malfunction due to static electricity or external influence. In this case, press the POWER switch to OFF then ON
again to restore normal operation.