Omron CJ Series Connection Manual page 24

10
Check that USB is set as the
network type in the Change PLC
Dialog Box. Click OK.
*If the USB is not set as the
network type, select USB from
the pull-down list.
*If you changed Device Type in
step 8 or CPU Type in step 9,
the dialog box on the right is
displayed. Confirm that there is
no problem and click Yes.
Make sure that the program
was normally converted. ("0
errors" must be shown.)
(Although duplicated output
warnings were detected as
shown on the right, they are not
problems.)
11
Select Programs in the project
workspace.
Select Work Online from the
PLC Menu.
7．Serial Communications Connection Procedure
21