National Instruments NI cDAQ-9139 User Manual page 121

•
Video Configuration
submenu.
•
Power/Wake Configuration
Configuration submenu.
•
USB Configuration
•
Intel AMT Configuration
Configuration submenu.
•
Serial Port Configuration
Configuration submenu.
•
Serial Port Console Redirection
Console Redirection submenu.
SATA Configuration Submenu
Use this submenu to apply alternate settings to the hard disk drive (HDD) interfaces. Normally,
you do not need to modify these settings, as the factory default settings provide the most
compatible and optimal configuration possible.
• SATA Mode Selection—This setting determines whether AHCI mode is enabled or
disabled for the SATA port. Some operating systems, do not support AHCI mode. You can
use this setting to disable AHCI mode and enable IDE mode so that non-compatible OSes
function correctly. The default value is AHCI.
• Onboard Storage—This item displays the onboard drive detected in the system.
CPU Configuration Submenu
Use this submenu to apply alternate settings to the CPU. Normally, you do not need to modify
these settings, as the factory default settings provide the most compatible and optimal
configuration possible.
•
Hyper-Threading—
Hyper-Threading technology. The default value is Disabled if the boot OS is
LabVIEW Real-Time and Enabled for other boot OSes. Enabling Hyper-Threading
increases performance for some applications by adding virtual CPU cores.
Hyper-Threading can cause control algorithms to behave less deterministically.
• Enabled CPU Cores—This setting selects the number of active CPU cores for the
processor. Valid values are 2 and 1. The default value is 2.
•
Turbo Boost—
technology. The default value is Disabled if the boot OS is LabVIEW Real-Time and
Enabled for other boot OSes. Enabling Turbo Boost allows CPU cores to run at higher than
their base frequency for short durations, while other cores are idle. Enabling Turbo Boost
can cause control algorithms to behave less deterministically.
• Hardware Prefetcher—This setting enables or disables CPU cache hardware prefetching.
The default value is enabled.
• Adjacent Cache Line Prefetch—This setting enables or disables prefetching of adjacent
cache lines from memory to the CPU cache. The default value is enabled.
Submenu—Use this setting to access the Video Configuration
Submenu—Use this setting to access the Power/Wake
Submenu—Use this setting to access the USB Configuration submenu.
Submenu—
Submenu—Use this setting to access the Serial Port
Submenu—Use this setting to access the Serial Port
(NI cDAQ-9139)
This setting enables or disables Intel Turbo Boost
(NI cDAQ-9139)
Use this setting to access the AMT
(NI cDAQ-9139)
This setting enables or disables Intel
NI cDAQ-9138/9139 User Manual
© National Instruments | A-5