Advertisement
Preparation for Installation
Note: To prevent data loss, read this manual thoroughly before installing or operating the DataPort.
Before touching any electrical equipment, ground yourself by touching the metal part of your computer chassis.
This discharges static electricity and prevents any damage to your computer. CRU is not responsible for static
discharge damages.
Tools Required:
e
Phillips screwdriver.
e
Small flat screwdriver.
Other items that may be needed are:
e
Hard drive manual to set the SCSI ID for a SCSI drive or to set the master or slave mode for an IDE drive.
e
SCSI bus terminator. For external application, a 50-pin SCSI passive or active terminator should be used to ter-
minate the end of the SCSI chain. For internal application, an internal SCSI bus terminator, usually a 220 Ohm
resistor pack, is installed on the SCSI drive.
Advertisement
Need help?
Do you have a question about the DataPort I and is the answer not in the manual?
Questions and answers