Table of Contents
Advertisement
Administrator Information
Group Policy Setting Items
Items
Enable this Group Policy
Access Control
Configure a control method for traffic of IP packets.
Items
Permit Access
Refuse Access
IPsec
Local Address(Printer)
Select an IPv4 address or IPv6 address that matches your network environment. If an IP address is assigned
automatically, you can select Use auto-obtained IPv4 address.
Note:
If an IPv6 address is assigned automatically, the connection may be unavailable. Configure a static IPv6 address.
Remote Address(Host)
Enter a device's IP address to control access. The IP address must be 43 characters or less. If you do not enter an IP
address, all addresses are controlled.
Note:
If an IP address is assigned automatically (e.g. assigned by DHCP), the connection may be unavailable. Configure a static IP
address.
Method of Choosing Port
Select a method to specify ports.
❏ Service Name
If you select Service Name for Method of Choosing Port, select an option.
❏ Transport Protocol
If you select Port Number for Method of Choosing Port, you need to configure an encapsulation mode.
Items
Any Protocol
TCP
UDP
ICMPv4
>
Advanced Security Settings
Settings and Explanation
You can enable or disable a group policy.
Settings and Explanation
Select this to permit configured IP packets to pass through.
Select this to refuse configured IP packets to pass through.
Select this to permit configured IPsec packets to pass through.
Settings and Explanation
Select this to control all protocol types.
Select this to control data for unicast.
Select this to control data for broadcast and multicast.
Select this to control ping command.
445
>
Encrypted Communication Using IPsec/IP Filtering
Advertisement
Table of Contents
