Remove The Dc-In Bracket; Remove The Memory Shielding - Lenovo Legion Pro 5i Hardware Maintenance Manual

Screw specifications
M2 × L4.0
M2 × L11.8
Go to
https://support.lenovo.com/partslookup
replacement part:
Lower case

Remove the DC-in bracket

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 28
Step 1. Disconnect the battery pack cable from the system board. Remove two screws and then remove
the DC-in bracket.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Figure 4. Remove the DC-in bracket
Screw specifications
M2 × L6.0
Go to https://support.lenovo.com/partslookup
replacement part:
DC-in bracket

Remove the memory shielding

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 28
Number of screws
4
6
to look up the Lenovo part numbers of the following
Number of screws
2
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
29