Graco TexSpray GM 1030 Instructions-Parts List Manual page 7

SETUP
3.
Connect the spring guard end of the 50 R
(15 m) material hose (85b) to the outlet of the
automatic pressure drain valve (2).
WARNING
A spring guarded material hose (85b) must be
drain valve. The spring guard helps protect the
Installed at the outlet of the automatic pressure
hose from stress and strain.
4. Connect the gun air hose (85a) to the Easy SPMY
Control
(75).
5. Connect additional material and air hoses up to
150
ft
(45 m). See page 38 to order.
6.
Connect the air and material hoses to the gun
and tighten securely.
7. Connect a 1/2" ID compressor air hose (customer
supplied) to the air regulator inlet (C). Do not use
quick disconnect couplers.
8.
Tighten the pump's lug nut
(214)
very tight using
a hammer. This helps prevent air leaks which
prevent priming.
9.
Clamp the siphon hose to the pump. Be sure the
gasket is in place in the quick disconnect elbow
(le)
-
air leaks will prevent priming.
IO. Connect the drain hose (86) to the rear outlet
of
the automatic pressure drain valve (2).
11. Install the hose clips
(83)
on the siphon hose and
drain hose as shown.
' C
01811
Fig 5
12. See page 9 for disc and nozzle recommenda-
tions. Install the disc (A) and nozzle (B) on the
gun. as shown in Fig 5. Tighten the retaining rings
(C and D) snugly, but do not use a wrench.
13. Add Throat Seal Liquid, supplied, to the Pump
wet cup (B) until it is visible at the top of the cup.
14. Check the engine oil level. Refer to the Honda
engine manual, supplied. In summary: remove
one oil fill plug (E)
-
the oil should be almost
overflowing. Add oil as necessary. Also read the
MAINTENANCE section on page 12.
Recommended engine oil: Use a high-quality,
detergent oil, SAE IOW-40, classified "FOR
SERVICE SE or SF".
start, if it is low on oil. If you
try
to start it again without
NOTE: The engine stops automatically, or will not
adding more oil, a red light near the engine on/off
switch glows
as
you pull the starter rope.
15. Fill the
gas
tank. See FUELING, page 11.
16. Agitate or mix the material thoroughly1 Make sure
the heavier material on the bottom of the contain-
er is completely mixed in.
17. Start the sprayer. See page 8.
308-269 7