Graco TexSpray GM 1030 Instructions-Parts List Manual page 22

CLUTCI
NOTE The clutch assembly (9) includes the armature
(9b) and rotor (Sa). The armature and rotor must be
replaced together
so
they wear evenly.
NOTE If the pinion assembly
(19)
is not yet sepa-
rated from the clutch housing, follow Steps
l
to 4.
Otherwise, start at Step
5.
1.
Follow the Pressure Relief Procedure Warning
on page
1 7 .
2.
Dlsconnecl the hose from the displacement
pump. Disconnect the cord set
(62)
from the pres-
sure control.
3. Remove the bottom two screws (3) from the
clutch housing
(17)
and then remove the remain-
ing three screws
( 3 ) .
4. Tap lightly on the back of the bearing housing
(23)
with a plastic mallet to loosen the assembly
(D) from the clutch housing
(17).
Pull the assem-
bly away; the armature (9b) will come with
it.
5.
6.
7.
4
Remove the m a t u r e from the pinion.
There are two ways to remove the rotor (Sa):
a. Remove the capscrews (4) and lockwashers
( 2 ) .
Install two of the screws in the threaded
screws until the rotor comes
off.
See Fig
20.
holes in the rotor (Sa). Alternately tighten the
b. Use a standard steering wheel puller (A) with
two 1/4-28 x 3 or
4
in. long screws (6). Re-
place the short screws of the steering wheel
puller with the longer screws. Turn the screws
Tighten the capscrew (C) of the tool until the
(B)
into the threaded holes of the rotor (93.
rotor comes off. See Detail in Fig
20.
Skip ahead to Reassembly, page
27,
Step
6,
or
continue on page
2 3 .
22
308-269