Graco TexSpray GM 1030 Instructions-Parts List Manual page 26

1.
2.
3 .
Install the clutch housing (17), capscrews (1 1)
and lockwashers (12) on the engine. See Fig 26.
Install the engine shaft
key
(14). See Fig 26.
Install the clamp (15) onto the engine shaft (A).
Maintain the 1.99 in.
f
0.01 (50.54 mm) dimen-
sion shown in Fig 27.
To check the dimension, place a rigid, straight
steel bar
(8)
across the face of the clutch housing
sure the distance between the inside of the bar
(17). Use an accurate measuring device to mea-
and the face of the clamp. Adjust the clamp as
m e s q . Torque the two screws (72) to 125 in-
Ib (14 N.m).
evenly
to
In-t
(2.8 N.m)
Torqueop
d e and
,
4. Connect the wires of the hamess (69) to the
screws
(57)
in both places on the field. Pull the
plastic caps (C) up and snap them over the
screws. Guide the wires of the harness (69)
through the slot in the clutch housing. Slide the
field
(IO)
into the clutch. Align the setscrew
chamfers in the field and the clutch housing (17).
Tighten the setscrews (16) oppositely and evenly,
to 25 in-lb (2.8 Nm). See Fig
26.
A
here befoie sliding field
(10)
Conned
wiring hamess (69)
Into houdng
(17)
Torque to
125
In-lb
(14 N.m)
A
SIDE CUTAWAY VIEW OF CLUTCH HOUSING
Flg 27
w50
Fig 26
oora