Graco TexSpray GM 1030 Instructions-Parts List Manual page 27

REASSEMBLY
NOTE
Refer to Fig 28 for Steps 5 to 9.
8. Be sure the face of the
armature
f9b)
is clean.
5.
Place the engine
(45)
on the cart. Align the
wiring harness (69) through the mounting plate
mounting holes. Guide the engine wire (A) and
grommets (8). Install the screws (42) and nuts
capscrews (5), lockwashers (6) and washer (7)
(43) and torque to 15 ft-lb (20 N.m). Install the
from under the engine mounting plate to secure
the clutch housing (17). Connect the like-colored
wires as shown in the Detail A.
Assemble the armature to the shaft i n the pinion
armature makes it difficult to assemble these
housing (C).
A
retaining ring located within the
parts. For the best results, first engage a few
splines of both parts, then use a screwdriver to
and then engage the remalnlng splines. Push the
gently push the retaining ring into the armature,
armature onto the shaft until it contacts the ring.
6. Be sure the face of the
rotor
(sa)
and the field
(10)
is free of all oil and contaminants. Installthe
rotor, lockwashers (70) and capscrews (72).
Torque the capscrews to 7 ft-lb (9.5 N.m).
9.
Assemble the drive/pinlon housing (C) to the
clutch housing, using the capscrews (3) and lock-
washers (2).
10. Connect the cord set (62) to the pressure control.
7. After installing the rotor (Sa), pull the engine recoil
rope to assure that the engine tums freely and
there is no friction between the rotor (Sa) and the
field (10).
If
there is friction, loosen the setscrews
(16) and reposition the field (10) as necessary.
Tighten the setscrews oppositely and evenly to
25 in-lb (2.8 N.m). Also make sure there are no
burrs on the outside edge of the rotor.
DETAIL A
A
Torqueto
7
ft-lb
(8.5 N.m)
Faces musl
be
clean
C Green wlred
A
Torque to
15ff-Ib (20.4 N.m)
Fig
28
0105
308-269 27