Graco TexSpray GM 1030 Instructions-Parts List Manual page 3

HOSE SAFETY
Use only genuine Graco hoses and replacement Handle and route hoses carefully. Do not pull on
hoses as shown on page 30 and page
34.
The
hose hoses to move equipment. Keep hoses clear of mov-
used at the sprayer outlet must have a spring guard ing parts and hot surfaces of the pump and gas en-
at that end.
gine. Do not use fluids or solvents which are not com-
Tighten all fluid connections securely before each
patible with the inner tube and cover of the hose. DO
NOT exDose Graco hoses to temperatures above
use;
Do not use a damaged or repaired hose. Before each
use, check the entire hose for cuts, leaks, abrasion, If the hose develops a leak, split or rupture due to any
couplings. If any of these conditions
exist,
replace the
bulging cover, or damage or movement of the hose kind of wear, damage or misuse, the spray coming
from it can cause splashing on the eyes or skin or
hose immediately. property damage.
FIRE OR EXPLOSION HAZARD
The
GM 1030 TexSpray Sprayer are intended for use
sory, GM 3012, you must provide complete system
outside and with texture materials at low application grounding, as explained in manual 308-127,
pressures. If you are using the sprayer for any other supplied with the GM 3012.
application, including the high pressure pump acws-
MOVING PARTS HAZARD
Moving parts can pinch or amputate fingers or other
body parts. KEEP CLEAR of moving parts when start-
lief Procedure above before checking or servicing
ing or operating the sprayer. Follow the Pressure Re-
any part of the sprayer, to prevent
it
from starting acci-
dentally.
IMPORTANT
These standards
-
particularly the General Standards, Part 1910, and the Construction Standards, Part 1926
-
United States Government safety standards have been adopted under the Occupational Safety and Health
Act.
should be consulted.
180-
F
(82. C) or below -40Q F
(-40'
C).
308-269
3