CLAMP
two1/4-28 x
3 or
4 in. long screws are required to
NOTE: A standard steering wheel puller and
remove the clamp.
NOTE: Refer to Fig 24.
1. Loosen the
two screws (4) on the clamp (15),
working through the slot at the bottom of the
clutch housing (17).
2. Install
two screws (B) of the tool (A) in two of the
threaded holes in the clamp. Tighten the screw
(C) until the clamp comes
off.
3 . Go to
Reassembly, page 26, Step
3, or continue
below. .
Torque
125
in-ib
to (14 Nm)
Fig
24
0156
CLUTCH HOUSING
NOTE Refer to Fig 25.
1. Remove the capscrews (1 1) and lockwashers (12)
which hold the clutch housing
(17) to the engine
(45).
2. Remove the engine key (14).
3. Pull off the clutch housing
(17).
4. Go to Reassembly, page 26, Step 1.
1
Fig
25
OlW
308-269
25