Some Advice In Case Of Combustion Problems - Nordpeis Salzburg C Installation Manual

Some advice in case of combustion problems

Error
The chimney is blocked
7KHÀX H LV V R RW\ RUWKHUHLV DFFX P X O D WHGV R RWRQWKH
No draught
V P RNHED‰ H
7KHV P RNHED‰ H LV ZURQJO \ SRV L WLRQHG
Downdraught in the room caused by no draught, that the
house is too "air tight".
Downdraught in the room – caused by extractor and/or
central ventilation system that pulls too much air out of
the room.
7KHÀX H V IURPWZR¿ U HSO D FHV V W RY H V DUHFRQQHFWHGWR
the same chimney at the same height.
7KHÀX H LV LQDGHFO L QLQJSRV L WLRQIURPWKHV P RNHGRPH
to the chimney.
7KHÀX H LV WRRIDULQWRWKHFKLPQH\
The stove
release smoke
Soot hatch in the basement or attic that is open and thus
when lighting
creating a false draught.
WKH¿ U HDQG
during combus-
'DPSHUWRSGUDX J KWY H QWV RUGRRUV RQ¿ U HSO D FHV WKDWDUH
tion
not in use are open and create a false draught.
$ Q RSHQKRO H LQWKHFKLPQH\ DIWHUWKDWD¿ U HSO D FHKDV
been removed, thus creating a false draught.
Defect masonry in the chimney, e.g. it is not airtight
DURX Q GWKHÀX H SLSHHQWU\ DQGRUEURNHQSDUWLWLRQLQV L GH
the chimney creating a false draught.
The cross-section in the chimney is too large which
results in no or very low draught.
The cross-section in the chimney is too small and the
chimney cannot carry out all the smoke.
The chimney is too low and hence a poor draught.
The stove The chimney is too low in relationship to the surrounding
releases smoke
terrain, buildings, trees etc.
inside when
Turbulence around the chimney due to the roof being
it is windy
WRRÀDW
outside.
The combustion receives too much oxygen due to a
The stove does
leakage under the lower border of the stove or too strong
not heat suf-
FKLPQH\ GUDX J KW'Lˆ F X O W WRUHJX O D WHWKHFRPEX V W LRQDQG
¿ F LHQWO\
the wood burn up too quickly.
7KHVPRNHEX‡ H ULVZURQJO\ SRVLWLRQHG
In case of using oven-dried wood, this requires less air
Too much
supply than when using normal wood.
draught
7KHJDV N HWV DURX Q GWKHGRRUDUHZRUQDQGWRWDO O \ ÀDW
The chimney is too large.
The wood is too wet.
The glass is
sooty
The air vent control is closed too tightly.
Bad combustion (the temperature is too low)
White glass
Using wrong material for combustion (such as: painted
or impregnated wood, plastic laminate, plywood etc)
A levelling out of pressure occurs in the burn chamber.
Smoke is relea-
sed when the
7KHGRRULV RSHQHGZKHQWKHUHLV D¿ U HLQWKHEX U Q
door is opened
chamber.
The combustion temperature is too low.
White smoke
The wood is humid and contains water damp.
Black or grey/
,QVX ˆ F LHQWFRPEXVWLRQ
black smoke
Explanation
Contact a chimney sweeper / dealer for more information or clean
WKHÀX H V P RNHED‰ H DQGEX U QFKDPEHU
9HULI\ WKHDV V H PEO \ RIWKHV P RNHED‰ H V H HDV V H PEO \ LQV W UX F WLRQV
/LJKWWKH¿ U HZLWKDQRSHQZLQGRZ,IWKLV KHO S V PRUHELJJHUY H QWV
must be installed in the room.
7X U QR‡ UHJX O D WHH[WUDFWRUDQGRURWKHUY H QWLO D WLRQ,IWKLV KHO S V
more vents must be installed.
2QHÀX H PX V W EHUHSRV L WLRQHG7KHKHLJKWGL‡ H UHQFHRIWKHWZRÀX H
pipes must be of at least 30 cm.
7KHÀX H PX V W EHPRY H GV R WKDWWKHUHLV DQLQFO L QDWLRQRIDWO H DV W
10º from smoke dome to chimney. Possibly install a smoke suction
device*.
7KHÀX H PX V W EHUHFRQQHFWHGV R WKDWLWGRHV QRWHQWHULQWRWKH
chimney but ends 5 mm before the chimney inner wall. Possibly
install a smoke suction device*.
Soot hatches must always be closed. Hatches that are not tight or
are defected must be changed.
& O R V H GDPSHUGRRUV DQGWRSGUDX J KWY H QWV RQ¿ U HSO D FHV WKDWDUH
not in use.
+RO H V PX V W EHFRPSO H WHO \ V H DO H GR‡ ZLWKPDV R QU\
Seal and plaster all cracks and sites that are not tight.
7KHFKLPQH\ PX V W EHUH¿ W WHGSRV V L EO \ LQV W DO O DV P RNHV X F WLRQ
device*.
& K DQJHWRDV P DO O H U¿ U HSO D FHRUEX L O G QHZFKLPQH\ ZLWKDO D UJHU
cross section. Possibly install a smoke suction device*.
Increase the height of the chimney and/or install a chimney cap/
smoke suction device*.
Increase the height of the chimney and/or install a chimney cap/
smoke suction device*.
Increase the height of the chimney and/or install a chimney cap/
smoke suction device*.
$ Q \ SRV V L EO H O H DNDJHPX V W EHV H DO H GR‡ $ GUDX J KWUHJX O D WRURU
possibly a damper can reduce the chimney draught. NB! A leakage
of only 5 cm2 is enough for 30% of the heated air to disappear.
9HULI\ WKHSRVLWLRQLQJRIWKHVPRNHEX‡ H U± VHHDVVHPEO\ LQVWUXF
tions.
Turn down the air supply.
Replace the gaskets, contact your dealer.
Contact chimneysweeper or other professional for more details.
2QO \ X V H GU\ ZRRGZLWKDKX P LGLW\ RIPD[LPX P
2SHQWKHDLUY H QWFRQWURO WRDGGDLUWRWKHFRPEX V W LRQ:KHQQHZ
wood logs are inserted all vent controls should be completely
RSHQHGRUWKHGRRUV O L JKWO \ RSHQHGX Q WLO WKHÀDPHV KDY H DJRRG
take on the wood.
Follow the guidelines in this user guide for correct combustion.
Ensure to use only dry and clean wood.
2SHQWKHDLUY H QWFRQWURO IRUDERX W PLQEHIRUHRSHQLQJWKHGRRU
– avoid opening the door too quickly.
2SHQWKHGRRUFDUHIX O O \ DQGRURQO \ ZKHQWKHUHLV KRWHPEHU
Increase the air supply.
Ensure to use only dry and clean wood.
Increase the air supply.
GB
Solution
-
9