Safety Precautions; Daily Maintenance; Auto Cleaning - Formax FD 8400HS Maintenance Manual

High security shredder cross-cut
Hide thumbs Also See for FD 8400HS:
Table of Contents

Advertisement

Safety Precautions

To avoid personal injury, and damage to the shredder, observe the following safety precautions. Please keep
these instructions for future reference.
NOTE: In case of emergency, push the ON/OFF button on the
right side, or pull the plug out of the wall outlet.
Keep hands, long hair, clothing, ties, jewelry and other loose
items away from the paper entrance.
Do not use the shredder for anything other than its intended
purpose. Never use it to shred cloth, plastic, cardboard or any
hard material that will cause damage to the shredder blades.
DO NOT SHRED STAPLES OR PAPER CLIPS.
Do not allow children to use the machine.
Do not operate with a damaged power cord or plug, or when
the machine is damaged in any manner.
Unplug the shredder when it is being moved, or if it is not in use for an extended period of time.
Do not disconnect the power by pulling only the cord. Hold the plug when disconnecting.
Keep the shredder away from direct sunlight.
Do not sit on the shredder or place anything on top of it.
Never open the fixed switch or cover.

Daily Maintenance

Disconnect power by pulling power cord plug from wall outlet.
To clean the exterior, wipe the surface with a soft cloth. If the surface is very dirty, use a neutral detergent,
then wipe again with a soft cloth.
CAUTION:
Never put water directly on the surface of the shredder.
Never clean the case with benzene or thinner, since it will cause discoloration.
Do not dismantle the shredder. Contact your Formax Dealer for service.
Auto Cleaning Function
Use the Auto Cleaning function when sheet capacity is decreased.
1. Prior to using the Auto Cleaning function, spread shredder oil onto the cutters through the shred opening,
and allow the oil to sit for a few minutes to permeate the cutting blades.
2. Press the REV button and hold for five seconds. Manual and Rev LED indicators on control panel will light.
3. The shredder will operate in reverse for one minute, then the Auto LED will light.
3

Advertisement

Table of Contents
loading

Table of Contents