Table of Contents
Advertisement
WIRING
RED WIRE: +12V POWER INPUT (15 Amp Fuse)
Connect to a +12 Volt source with the supplied fuse and fuse-holder. We recommend the connection to be at the
Vehicle's Battery Positive Terminal.
BLACK WIRE: CHASSIS GROUND
THIS WIRE MUST BE CONNECTED TO THE CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt to
ensure a good connection. We recommend the kick panel area for your ground point.
YELLOW WIRE: IGNITION SWITCHED "ON" and "START" +12 VOLTS
Connect to a (+) Ignition Wire that shows +12 Volts when the key is in both the "ON" and "Cranking" positions.
ORANGE WIRE: (-) NEGATIVE ARMED OUTPUT
Ground output when system is armed. This output can be used for additional starter disable relay or to activate other
devices such as scanner LED's, window modules, voice modules etc.
WHITE WIRE: +12V FLASHING PARKING LIGHT OUTPUT (Optional)
Connect to switched parking light wire at back of light switch or connect directly to one of the parking lights at the front
of the vehicle. European vehicles may require additional parts due to separate left and right circuits.
BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.)
Connect to the siren's RED wire. Connect the Siren's Black Ground wire to the chassis close to the siren.
BLUE WIRE: (-) HOOD/TRUNK TRIGGER
Input trigger for a grounding hood or trunk pin switch. Connect to existing hood and trunk pin switches that read
ground when open. If no existing switches are available, install new grounding pin switches if desired. Note: DO NOT
mount new pin switches in water drainage or pathways.
GREEN WIRE: (-) DOOR TRIGGER
Connect to Negative type door switches that read ground when a door is opened and 12 volts when all doors are
closed. In the case of isolated door triggers, you may need to run additional wires from other doors OR go directly to
the wire that triggers the vehicle's dome light.
VIOLET WIRE: (+) DOOR TRIGGER
Connect to Positive type door switches that show +12 Volts when the door is open and Ground when the doors are
closed. (Many Ford vehicles.)
GRAY WIRE: (-) REMOTE OUTPUT 1 (Optional, Requires Relay)
Connect this wire to terminal 85 of a relay to operate AUX device or function. Connect terminal 86 or the relay to +12
Volts constant. Connect terminal 87 to 12Volts or Ground depending to the type of circuit needed. Connect Terminal
30 to the AUX device's activation wire. This output will provide a ½ second ground pulse when AUX 1 is activated.
Advertisement
Table of Contents
