Table of Contents
Advertisement
Adjusting Rewinder Torque
If you find than the rewinder is pulling the liner out of the guide slots, reduce the torque by
turning the shaft counterclockwise. If you find that the liner wrap on the guide rollers is too
loose, increase the the torque by turning the shaft clockwise. Adjust the torque in small
increments of a quarter turn at a time by holding the wrench in place on the torque
adjustment nut and turning the rewinder shaft.
Warning: Do not tighten the nut to its stop in either direction.
Torque Adjustment Nut
Page | 34
Wrench (included)
Rewinder Shaft
Advertisement
Table of Contents
