Table of Contents
Advertisement
Section 5: Settings Overview
5A. Application Speed
High-Speed Mode (default): 5.6 in. [15.2 cm] / second
This mode is used for the most common labels. Labels 6 in. [15.2 cm] or wider or labels with
very aggressive adhesive may cause motor stalling. If you experience motor stalling, switch to
High-Torque Mode.
High-Torque Mode: 3 in. [7.6 cm] / second
This mode provides more motor torque to handle larger supply rolls and the most peel-resistant
labels. To activate High-Torque Mode, hold down the foot switch while switching on the unit.
To switch back to High-Speed Mode, hold down the foot switch again while switching on the
unit.
5B. Label Counter Mode
By default, your applicator will display the number of labels applied. This value will temporarily
disappear when viewing or changing other modes, but the current value will be redisplayed
automatically. To reset the value to "0", press and hold the "Recall/Reset" button for 5 seconds.
5C. Label Application Modes
Press "Mode" button once to display current label mode
(designated by L on display). Use "Recall/Reset" button to
select number (0-9).
Single-Label Mode: L 0 displayed
In this mode, one label is applied when the
foot switch is depressed. After selecting label
mode "0" and waiting 2 seconds, the unit will
store this setting and revert back to Label
Counter Mode.
Double-Label Mode: L 1 – L 9 displayed
In this mode, two labels are applied when the foot switch is depressed. The number displayed
represents a discrete memory location which will be shortly followed by a corresponding number
indicating the distance between labels in inches or centimeters, depending on the current unit of
Page | 27
Press once to
enter this mode
Press to toggle
memory locations
Adjust distance
between labels
Advertisement
Table of Contents
