Table of Contents
Advertisement
measure. Use "+ / -" buttons to adjust the distance for that memory location. After 8 seconds,
the unit will store the mode and setting and the display will revert back to Label Counter Mode.
5D. Container Roller Modes
Press "Mode" button twice to display current container roller mode (designated by C on display).
Use "Recall/Reset" button to select number (0-9). After selecting the desired container rolder
mode and waiting 8 secondes, the unit will store the mode and
setting and the display will revert back to Label Counter Mode.
Immediate Stop Mode: C 0 displayed. This mode stops the
container immediately after label application.
Delayed Stop Mode: C 1–8 displayed. Use this mode if you wan
to printer on the label or container using an accessory printer.
(not included) Rotation after application is usually required to
locate printing where desired.
The number displayed indicates the rotation distance after
label application (after the second label in Double-Label Mode).
Each unit equals 4.3 inches [10.9 cm]. For example: After the
entire label is applied, C 2 rotates the container roller 8.6 in.
[21.8 cm] before stopping.
Demo Mode (continuous rotation): C 9 displayed.
5E. Units of Measure
English (inches)
In this configuration "-" will be the first digit of the firmware version displayed during unit start up.
To change to English from metric, press and hold "Mode" and "+" buttons simultaneous while
switching on unit.
Metric (centimeters)
In this configuration "=" will be the first digit of the firmware version displayed during unit start up.
To change to metric from English, press and hold "Mode" and "-" buttons simultaneous while
switching on unit.
Page | 28
Press 2x to
Press to add
Enter this mode
rotation distance
after application
Advertisement
Table of Contents
